SANSI LED Security Lights Outdoor, Motion Sensor Flood Light, 45W (600W Equiv.) 6000lm, Super Bright, Dusk to Dawn Lights with Wide Angle Illumination, IP65 Waterproof, 5000K Daylight, White

Compared with other security lights, SANSI LED security motion activated light can be rated at 6,000lm just with 45W, which is far brighter to provide security for your home or business accommodations. You could cut down your electricity bill by up to 85%.Compared with traditional motion sensor light for outdoor, it has more working modes. Not only owns Test, Auto Mode but also includes Dusk to Dawn Mode and On-Time Mode. 4 different working modes will meet your needs. PACKAGE INCLUDED: 1 x SANSI LED Security Light 1 x Bar-shaped Mounting Plate 1 x Waterproof Gasket and 3 x Screws 3 x Wire Connectors 1 x Mounting Bolt 1 x Rubber Screw Plug 1 x Instruction Booklet Light turns on automatically at dusk or night and turns off at dawn or if it’s too bright for your sensor.D2D Mode only works at night. When its bright around the sensor, it goes off automatically. Except Lux, Time and Range doesnt work while using this mode.Light turns on for only 5 seconds during daytime or night once it detects motion.This mode is used for checking whether the sensor is working properly.Test Mode can work during daytime and night. Except Range, the Lux and Time Setting doesnt work while using this mode.When sensor detects motion, it lights up for 1-10 minutes according to the time it has been set.While using auto mode, toggle switch off and 2 seconds later on again. Light turns on continuously for ca. 8 hrs and goes off at daytime.Auto Mode only works at night. When its bright (> 100-150 LUX) around the sensor, light goes automatically back to Auto Mode.Light can work as a standard LED light without motion sensing.Light turns on when switch on, turns off when switch off.On Time Mode can work during daytime and night. The Lux, Time and Range Setting doesnt work while using this mode.Time knob is used for setting working time from 1-10 minutes when it detects motion.Time setting only works in Auto Mode.For setting ambient brightness value to differ from daytime to night. If the ambient brightness value exceeds the setting Lux, it is defined as "daytime"; otherwise its known as "nighttime".Position 0 equals 3 Lux, Position ? equals max Lux and its always regard as night no matter how bright around the sensor.Lux setting only works in Auto Mode and D2D Mode.Rotate the knob to adjust the sensing range to max ca. 50ft motion coverage.When you mount the light over 7.8ft, please adjust the sensor upwards and set max range to increase the coverage area. Time setting only works in Auto Mode.Range setting only works in Test Mode and Auto Mode.Make sure that there are no infrared or ambient lights pointing towards the motion sensor.Make sure that there are no other influence factors affect the performance of light.Be sure to disconnect the power before you install the light.Be sure to mount it in dry location, humid environment is not good for lights lifespan.The light is suggested to install with the height from 3.2 ft to 13.1 ft to the ground. The best height is 8.7 ftTo get the best performance of the D2D light, the recommended lux setting is halfway on the LUX knob.If the light is mounted under the soffit or ceiling, it is strongly suggested to adjust the sensor head, i.e., put the light sensor away from the 2 lamp wings, otherwise, it will be interference from the light reflecting