42 Inch Retractable Blades Industrial Retro Ceiling Fans with Lights and Remote Vintage Caged Chandelier Fans Invisible Chandelier Fan Light Kit for Bedroom Dining Room Office Farmhouse Basement

Equipped with 5 E27 socket bases, it is widely compatible with LED, CFL, incandescent, halogen and Edison bulbs. Each bulb is recommended to have a maximum of 40W.Warm Tips: not including bulb. What’s in the box: Retractable ceiling fan x1 Screws sets x1 Down rods x 2 (Rod length: 7.84" and 3.97") Remote control x1 Instruction Manual x1 Copper motor, Inserted with quiet motor, Stable and strong power supply, maintain the silent living environment, brings your comfortable living and sleeping experience.High-quality motor, long service life, average practical life of 5-10 years. Installation Notes: Floor height suggest greater than 110 inches. Ceiling load greater than 30kg. Ceiling tilt angle is smaller than 20 ° This fan needs basic assembly, professional would be highly recommended. If the remote control does not work, please check the remote control battery first. No matter what difficulties you meet, we will always in your service! Remove the R-shaped safety pin and connecting bolt.Pass Downrod through two cover,Then pass the wire through Downrod.Then put into the connector, and insert the connection bolt and R-shaped safety pin,then tighten the screw.Remove the Motor Chassis and 3 screws,Install 4 screws and nuts on the fan case in the right direction,then Replacing.Then connect the white wire to the white wire,Blue line to black line.The screws on the chassis go through the screw holes of the cage fixing device, Screw the nut and protective cover.The input power of the remote control is divided into 2 lines,Black wire to power line,White wire to power neutral.The output power is 3 wires,Connected to the corresponding color on the motor.The yellow wire on the host must be connected to the household wire.Place the Ceiling Fans Downrod in the Bracket and rotate it.Ensure that the groove on the hanging ball engages with the ear on the hanger.Organize the wires, adjust the Cover, and tighten the screws.